Tiling Over Existing Shower Floor Tiles

If the existing shower is correctly installed there is no way that the tiles on the floor of the shower can be level as pitch from the walls to the drain is required for the water to drain.

Tiling over existing shower floor tiles.

Step 1 clean and prepare the tile floor. And it lasts for 20 years. This assumes that the floor underneath is solid concrete and that there are no cracks in the existing tile indicating underlying problems in the concrete. Lay grout able peel stick vinyl over the existing tile vinyl peel stick flooring or vtf has come a long way from the vinyl tile flooring options that were popular in the 1980 s.

Removing existing tile before installing new tile is recommended however sometimes old tile can be very difficult or almost impossible to remove. One advantage of doing this is that it is time saving. Available at stores like home depot and lowes these peel and stick tiles are available for less than 1 a square foot. The bad cuts can turn an otherwise good looking tile floor into an amateurish looking maintenance nightmare.

Tile on tile or as i say it. If your old ceramic tile is worn or dated you can lay new tile right over the old and avoid the huge job of tearing out the old tile. Many shower floors have cut tile with sharp or rough looking edges. As much as i dispise pre mixed thinset for any application as a tile professional for 15 years i must strongly advise you to not give out advice to.

Laying a new layer of tile over the existing shower floor can solve these issues without removing the old tile and grout. Tiling over an uneven surface will give you less than stellar results so level out any globs of dried grout with a sander and secure loose tiles with fresh tile adhesive before beginning the project. In fact pros do it all the time. If the original tile is still in excellent condition then it is possible to install tile over tile but the proper steps must be taken in order to complete the project correctly.

If you expect to apply an epoxy coating then you need to get the finish to a point where it can accept the coating. Tiling over tile is usually a much easier and cheaper solution than pulling up your original tiles and re tiling your floor or wall. You do not have to allot work hours to pull up the existing tiles which means the tiling work can be finished much faster and all without the big mess.